05/02/2010

Plunger pump repair

 

In order to guarantee normal operation of plunger pump, Leo filter press ask every plunger pump users to take down the following items:

a. Please use clean hydraulic oil, please filter hydraulic oil every month and change hydraulic oil every three months

b. Pump should not be stared or work if no cooling water feeding into the pump, in order to prevent ceramic plunger breakage and rubber gasket damage due to overheat or overcool suddenly. Besides ,the cooling water also can be used in ceramic cleaning to prolong plunger and gasket service time

More information for the plunger pump please visit: http://www.leofilterpress.com/filter_press/?311.html

 

2010-5-2 下午 7:54:36

The comments to this entry are closed.

NEXT POST
Plunger Pump Installation and Operation Instructions Plunger pump installation instructions Put the plunger pump on the foundation bed, measure horizontal adjustment, fasten plunger pump stand with anchor bolts(or not) in order to replace hydraulic oil and clean slurry feeding pipings, pump should be raise for 10cm higher than the ground, drainage for filtrate should be arranged around the pump foundation. Full text reading please click this link: http://www.leofilterpress.com/filter_press/?295.html
PREVIOUS POST
Instructions for filter press Plan and Erection As filter press is probably one part of a whole system or factory, the safety rules given herein is only applicable to the filter press in the factory. The following factors should be highly regarded: Abide by the safety instructions, even if taking the maximum safety factors in production equipment designing and planning. The safety devices efficiency will be decreased greatly or even result in dangers if the safety devices adopt wrong design. More information for this article, please visit: http://www.leofilterpress.com/filter_press/?329.html