04/25/2010

Filter Press Using Report Filter Cake Moisture content

Filter Press Using Report Filter Cake Moisture content

The problem the beverage producers then faced was how to dewater the sludge that was created.  Various alternatives, such as sludge drying beds, belt filter presses and recessed chamber presses were considered.  Representative samples of the sludge were created by simulating the chemical treatment of several hundred gallons of typical wastewater.  These samples were sent to the Leo Filter Press’s lab, in China The oil and grease content in the sludge inhibited effective dewatering, but the combination of pH control and a high molecular weight polymer created good flocculation of solids and effective dewatering was possible.

Based on these results, those beverage producers elected to purchase several recessed chamber filter presses to dewater the sludge generated by the chemical treatment of their average wastewater flow of 750,000 gpd. The technicians at Siemens Water Technologies worked closely with beverage producer operating personnel doing on-site test work with full automatic PLC control.

More information please visit: http://www.filterpress.cc/Html/?393.html

2010-4-25 下午10:37:40

The comments to this entry are closed.

NEXT POST
Filter Press Operation Filter Press Operation Plate and frame filter presses are used for wastewater dewatering by utilizing pressure (3-5 bar) to remove the solid from a suspension. They are particularly suited for low solids content (<2% solids), or solids composed of fines particles (-200 mesh), however they will essentially dewater a wide range of particle size distribution and various solid content slurries.Whe judging from a photo ,you can’t figure out immediately that it is a plate and frame type filter press, due to the same out-looking as chamber filter press .But when you look at the filter plate handles ,you will find...
PREVIOUS POST
Filter Press Plan and Erection As filter press is probably one part of a whole system or factory, the safety rules given herein is only applicable to the filter press in the factory. The following factors should be highly regarded: Abide by the safety instructions, even if taking the maximum safety factors in production equipment designing and planning. The safety devices efficiency will be decreased greatly or even result in dangers if the safety devices adopt wrong design. The following items should be checked upon the actual site situations when erecting and commissioning filter press For full text: http://www.leofilterpress.com/filter_press/?329.html